Automatic Rubber Setup - Rotary
Cut Rubber For Rotary Dies
Switch this option on to create rubber specifically for rotary dies. Rubber is added to the internal and external waste areas only, not inside the design. Typically a 'U-shaped' piece off rubber is added to each waste area. Enabling this option will disable the One-up Interior, Perimeter and Waste Areas pages (although see below).
Palette
From the pulldown list choose the palette in which to create the rubber.
Rubber thickness
Enter the width of the rubber.
Rubber to knife distance
Enter the offset from the knife to the rubber.
Mask
Switch this option on to mask either the upper-most or lower-most entity in the waste area.
Open end
Choose the required radio button:
- Top
- Bottom
Create one-up interior
Switch this option on to enable the One-up Interior page.