Dynamic Stripping Component

Dynamic Stripping Component - General

Name

Enter the unique MTS name.

Description

Enter an optional description for these settings.

Male Component

From the pulldown list choose the Male Component Library, and the default Male Component within that library, that should be placed when using this dynamic stripping component.

Paired Restrictions

Max Shared Component Offset

This value is used to determine the maximum distance between the two restrictions that is allowed before a single shared component placement is made between them. For distances greater than this, each restriction is given its own component placement instead (as if the restrictions were not paired).

Precisely, the shared component offset is the distance between the component anchor point (which is offset by the male component offset from the restriction) and the point at which a shared component would be placed.

Female Component

Default

From the pulldown list choose the default Female Component that should be placed when using this dynamic stripping component.

 

Dynamic Stripping Component - Cluster Components

This allows individual cluster components to be added to the dynamic stripping component

Add

This will open the Cluster Component form to create a new cluster component to add to the dynamic stripping component.

Add Cluster

This will open the Pre-defined Cluster form to create a set of new cluster components to add to the dynamic stripping component.

Change

This will open the Cluster Component form to change the settings of the highlighted cluster component.

Delete

This will delete the highlighted cluster component.

Did you find it helpful? Yes No

Send feedback
Sorry we couldn't be helpful. Help us improve this article with your feedback.

You may like to read -