This form is opened from the Stripper System - Breakers - Trim Waste form. It is used to configure a Trim Waste Female Symbol.
Trim Waste
Name
Specify a name for the trim waste female symbol, which will be displayed on the edit bar in the Stripper Creator.
Trim up to
Specifies the maximum trim distance for which this trim waste female symbol should be auto selected.
Female symbol
This allows you to select a symbol to be inserted to show the female part. The symbol is inserted relative to the default Female Symbol Depth offset.
If materials have been defined, material specific overrides can be made for this value by clicking the 
Material button.
Depth
This is the default value for the depth of female symbol.
If materials have been defined, material specific overrides can be made for this value by clicking the 
Material button.
Male component offset
This is the distance between the restriction and the anchor for any dynamic stripping component placed relative to it.
If materials have been defined, material specific overrides can be made for this value by clicking the 
Material button.
Neighbour distance
This allows you to define a distance to insert a side restriction either side of this part.
If materials have been defined, material specific overrides can be made for this value by clicking the 
Material button.