This is a sub-page from the Stripper System - Restrictions page.
Stripper System - Restrictions - Parallel Offset
These settings define the shape and size of Parallel Offset restrictions.
Width Ranges
Sets the standard lengths to determine the mode applied.
If materials have been defined, Material specific overrides can be made for this value by clicking the 
Material button.
The following settings are defined for both Inside and Outside/Perimeter strippers. You can set the Outside to be the same as the Inside by switching on the As above option.
Depth
This is the default value for the depth of the restriction.
If materials have been defined, Material specific overrides can be made for this value by clicking the 
Material button.
If the Warn if restriction width/depth is too small/large option has been checked on the DSC page, then Minimum and Maximum values can be defined here; warnings will be generated if the depth is set to be a value outside of this range in the Stripper Creator.