This is a sub-page from the Stripper System - Restrictions page.
Stripper System - Restrictions - Combi
These settings define the shape and size of Combi restrictions.
Side angle
This is the angle of the sides of the restriction; if 0 degrees then the sides are perpendicular to the profile and top edge of the restriction. Angles of 90 degrees and above are not valid.
Fillet radius
This is the radius of the fillet corner that is applied to the top edge of the restriction; if 0, then no fillets are used.
If materials have been defined, Material specific overrides can be made for this value by clicking the 
Material button.
The following settings are defined for both Inside and Outside/Perimeter strippers. You can set the Outside to be the same as the Inside by switching on the As above option.
Depth
This is the default value for the depth of the restriction.
If materials have been defined, Material specific overrides can be made for this value by clicking the 
Material button.
Width
This is the default value for the width of the restriction.
If materials have been defined, Material specific overrides can be made for this value by clicking the 
Material button.
Male Component Offset
This is the distance between the restriction and the anchor for any dynamic stripping component placed relative to it.
If materials have been defined, Material specific overrides can be made for this value by clicking the 
Material button.