Male Knife - Symbols

The Male Knife Symbols form is called from the Stripper Male Waste form.

Male Knife Symbols

These are legacy options.

Knife size

Displays a list of the defined knife sizes and corresponding symbols.

Add

Will open the Waste Component Symbol form to allow a new knife size and symbol to be defined.

Change

Will open the Waste Component Symbol form to allow the highlighted knife size and symbol to be edited.

Delete

Will delete the highlighted defined knife size and symbol.

Minimum spacing

Specifies the minimum distance between two automatically created knives offset at the same angle.

Maximum spacing

Specifies the maximum distance between two automatically created knives offset at the same angle.

Choose sizes for best coverage (recommended)

If this option is checked, on long straight sections where multiple knives must be used, then Impact will choose knife sizes such that the best coverage (pushing knives to the ends) is achieved.

Otherwise, Impact will fall back to an older method of choosing sizes, which may result in better symmetry at the expense of coverage.

Arcs 

  • Ignore - any non-straight edges will not be contoured. 
  • Approximate using lines - non-straight edges will be contoured using lines, placed automatically to be within the standard-minimum offset range at all times (there is no ‘conversion factor’).

Did you find it helpful? Yes No

Send feedback
Sorry we couldn't be helpful. Help us improve this article with your feedback.

You may like to read -