The Male Knife Components form is called from the Stripper Male Waste form.
Male Knife Components
Library
Specify the Male Component Library that should be used.
Maximum Spacing
Specify the maximum distance between two automatically created knives offset at the same angle.
Arcs
- Ignore - any non-straight edges will not be contoured.
- Approximate using lines - non-straight edges will be contoured using lines, placed automatically to be within the standard-minimum offset range at all times (there is no ‘conversion factor’).
Do not place these components automatically
For each component in the library, if this option is checked, then this component will never be used automatically (for a contour, slot or fill). However, it will still be available to place manually.