This form is opened from the Rubber Sheet Mappings form. It is used to define a sheet mapping.
Rubber sheet Setup - Sheet Settings
General Sheet Properties
Rubber Type
Enter a name for the rubber sheet.
Sheet Width
Enter the width of the sheet.
Sheet Height
Enter the height of the sheet.
Angular Sharpness
This is the minimum angle between two entities in a block to be nested. If an angle in the original geometry is less then the specified value, the angle will be changed to the minimum value in the nested block.
Sheet Margins
These values define the trim to be excluded from the nested area. Enter the four values.
Part Spacing
Protection Gap
Enter the distance between nested blocks.
Cutter Diameter
Enter the diameter of the tool to be used for cutting the nested blocks.
Rubber shet Setup - Palettes
Palettes
From the palette list select the palettes to which the sheet size is to apply.