Rotary Bridge Setup
Name
Enter the unique MTS name.
Description
Enter the description for this setting.
Bridge Mode
From the drop-down list select one of the following modes:-
- 1-2-1 method
- Equally spaced
- Spaced on teeth
This defines the initial positions for the bridges.
Symbol
A symbol can be added at either end of the path of entities that represents the rotary rule.
Name
Use the symbol selector to choose the required symbol.
Symbols at Path Ends
Switch this option on to add the symbols to the ends of the path.
Distances
Tooth Pitch
Enter the distance between adjacent teeth on the rotary rule.
Max Length with No Bridges
Enter the value that defines the bridge spacing limit. This is only relevant for the 1-2-1 and Equally spaced bridge modes.
Spaced on Teeth
These options are only relevant for the Spaced on teeth bridge mode.
Minimum Gap
Enter the minimum distance that is allowed between the end of the path and the final bridge.
Tooth Separation
Enter the number of teeth required between each bridge.
Standard Bridge
These values refer to normal bridges.
Width
Enter the required default bridge width.
Maximum Length
Enter the maximum length allowed between successive bridges.
Tie Bridge
These values refer to tie bridges.
Width
Enter the required default tie-bridge width.
Maximum Length
Enter the maximum entity length on which a tie bridge can be added.
Spanish Bridges
Select this option if the path should have a Spanish Bridge added at either end.
Width
Enter the required Spanish bridge width.