Edit > Bridge 
This tool enables you to add bridges to the female profile, and the wooden block, of the currently selected stripper area/region.
Edit bar controls
Bridge Width 
This option allows you to explicitly override the width of the bridge as defined in the System settings.
Auto Infer 
If this option is checked, then the tool will check for the same configuration of entities and blocks as the picked entity in other parts of the stripper area/region, and automatically place bridges here too.
These inferences will be linked so that editing one later will affect all of the inferences.
System Settings 
You can make a temporary override to the System settings currently being used by the Stripper Creator by changing the values shown in the Stripper System Settings form.
Area 
You can make a temporary override to the area helper settings currently being used by the Stripper Creator by changing the values shown in the Area Helper form. A defined area can then be displayed on the cursor to help gauge the size of any bridges added.
Angled 
If this option is checked, any editing of a selected component using the drag handles will allow changes to the angle of the component. Otherwise, the angle of the component remains fixed.
How to use the tool
Enter the Bridge Width 
to be applied, then identify the position of the bridge by snapping the point to the profile of the selected stripper area/region. If a wooden block has been added, the bridge position will be added to the female and the wooden block.
Existing bridges within a selected region will be marked with drag handles of different shapes. These can be edited in the same way as the Select 
tool, without the need to explicitly start that tool.